How to Hang a Vintage Flora and Fauna Wall Mural
By Livettes Wallpaper: Modern Wallpaper For Any Space Free Shipping | Published: 2026-10-20
Category: How-to Guides
Learn how to hang a vintage flora and fauna wall mural step by step, from surface prep to final smoothing, with common mistakes to avoid.
Quick Answer
To hang a vintage flora and fauna wall mural, prepare a smooth, clean wall, then apply the self-adhesive panels one by one, aligning the pattern and smoothing out bubbles as you go.
Why Self-Adhesive Murals Are Easier Than Traditional Wallpaper
Unlike traditional wallpaper that requires paste and soaking time, a self-adhesive wall mural has a peel-and-stick backing. That means you can position, peel, and reposition panels during installation, which reduces waste and frustration.
The trade-off is that self-adhesive murals stick instantly on contact, so you need to work slowly and smooth from the center outward. If you rush, you can trap air bubbles that are hard to remove later.
What to Know Before You Start
The vintage flora and fauna wall mural comes as 6 panels, each 19 inches wide and 108 inches tall, covering a total area of 114 x 108 inches. Because the mural is water-resistant and gently cleanable, it suits living rooms, bedrooms, and even commercial spaces with a Class A fire rating.
Before ordering, measure your wall to confirm the mural dimensions fit your space. If your wall is taller or wider, you may need to trim panels or combine with another mural. Also, order a sample first to see the print quality and scale in person.
Step-by-Step Installation Guide
- Prepare the wall: Clean the wall with a damp cloth to remove dust and grease. Fill any holes or cracks and sand smooth. The wall must be dry, flat, and free of texture for the adhesive to stick evenly. Check that the wall is completely dry before you start; moisture can prevent adhesion.
- Mark a vertical guideline: Use a level to draw a straight vertical line where the first panel will go. This ensures the mural hangs straight, especially if your wall or ceiling isn't perfectly level. Measure from the corner, not the ceiling, to keep the line true.
- Peel and position the first panel: Peel back a few inches of the backing at the top of the panel. Align the top edge with the ceiling and the side with your guideline, then slowly press the panel down, smoothing with a squeegee as you go. Don't peel the entire backing at once; you need control to avoid misalignment.
- Align and apply the remaining panels: For each next panel, match the pattern edges carefully before pressing down. Overlap slightly if needed, then trim with a sharp knife for a seamless match. Check pattern alignment at the top, middle, and bottom before pressing the panel fully.
- Smooth out bubbles and trim edges: Use a squeegee to push air bubbles toward the nearest edge. If a bubble persists, prick it with a pin and smooth flat. Trim any excess at the ceiling, baseboard, and corners with a straightedge and craft knife. Work bubbles out immediately—once the adhesive sets, they become harder to remove.
Product Facts
- Vintage flora and fauna wall mural: The mural is self-adhesive, water-resistant, and printed with GreenGuard Gold certified inks. You can install it without paste, and it's safe for kids' rooms and easy to wipe clean.
Vintage flora and fauna wall mural
