How to Install a Faux Gold Chevron Backsplash

Quick answer

Installing a faux gold chevron peel and stick backsplash is a weekend DIY project that requires careful surface prep, precise alignment of the geometric pattern, and a steady hand to avoid air bubbles.

Step-by-step installation guide

1. Clean and dry the wall surface: Wipe the area with a mild cleaner to remove grease, dust, and residue. Let it dry completely. Any moisture or debris will prevent the adhesive from bonding, leading to peeling later. Check for smoothness with your hand; even slight bumps show through the thin material.
2. Measure and plan the layout: Measure the backsplash area and mark a level line where the first row will start. Dry-lay a few panels on the floor to see how the chevron pattern aligns at seams. Adjust the starting point so full chevron points are centered rather than cut awkwardly. A level line prevents the pattern from drifting off horizontally as you work upward.
3. Peel the backing and apply the first panel: Peel off a few inches of the backing paper, align the top edge with your level line, and press the exposed adhesive onto the wall. Slowly pull the rest of the backing while smoothing the panel outward from the center with a plastic smoother or a clean cloth. Avoid peeling the entire backing at once—it makes repositioning nearly impossible.
4. Align subsequent panels: Butt the next panel edge-to-edge against the installed one, matching the chevron pattern exactly. Press firmly along the seam. If the pattern shifts slightly, lift the panel gently and reapply—do not slide it once it touches the adhesive. A slight misalignment at the first seam multiplies across the wall; use a straightedge to check every few panels.
5. Cut around obstacles: Hold the panel over the outlet, switch, or corner. Press it lightly to create a crease, then cut along the crease with a sharp utility knife. For outlets, cut an X and trim the flaps so the cover plate hides the edges. Cutting too deep can score the wall; use a fresh blade and cut on a cutting mat when possible.
6. Smooth out air bubbles: After all panels are up, go over the entire surface with a plastic smoother or a credit card wrapped in a cloth. Work from the center toward the edges to push out trapped air. For stubborn bubbles, prick the spot with a pin and smooth again. Small bubbles often disappear within 24 hours as the adhesive sets, but large ones should be addressed immediately.

Product facts

• Faux Gold Chevron Print Backsplash: The Faux Gold Chevron Print Backsplash from Livettes delivers a clean, geometric design that enhances any kitchen, bathroom, or interior wall with a subtle touch of metallic elegance. This pattern adds visual interest without overwhelming the space, making it suitable for both focal walls and full backsplashes.

  

• Faux Gold Chevron Print Backsplash: Available in a variety of dimensions, from a 11"H × 8"W sample to full panels up to 15"H × 95"W. Ordering a sample first lets you confirm the color and finish match your lighting before buying larger panels.